PTFE lubricant for dry lubrication and use in food processing areas.

Grease- and oil-free lubricant for the lubrication of plastic, rubber or metal surfaces. Clean, dry and not sticky. Temperature resistance up to 250°C. As a lubricant, CRC Dry Lube-F is most effective where low speeds and light loads are involved. Recommended for use as a lubricant in food processing areas where incidental food contact may occur.

Categories: ,


General description

Grease and oil free lubricant for the lubrication of wooden, plastic or metal surfaces. Clean, dry and not sticky.
Resistant till 250°C.



• Particularly suitable for use in areas where a wet film lubricant cannot be used due to possible environmental
dust and dirt adherence.
• Clean, dry and non-oily.
• Functional over a wide temperature range.
• Produces a very low coefficient of friction.
• High temperature resistance.
• Safe on most rubbers, plastics and coatings. Test on sensitive or stressed materials before use.



• Plastic drives and sliding mechanisms.
• Fine mechanics.
• Pneumatic tools.
• Precision instruments.
• Valves.
• Surface treatment.
• Particularly suitable in low load, low speed applications.



• Shake well before use.
• Shake until the agitator ball moves freely in the can.
• To remove residues or excess product, use one of the CRC cleaners.
• Spray from a distance of approximately 20 – 30 cm.
• Allow to dry at room temperature.
• Do not use on energized equipment.
• To remove residues or excess product, use one of the CRC cleaners.
• A safety data sheet (MSDS) according to EC Regulation N° 1907/2006 Art.31 and amendments is
available for all CRC products.
• Based upon the present state of our knowledge and information received from our suppliers, evaluation of this

product indicates that it is free from nut oils and their derivatives.


Typical product data (without propellant)

Appearance Propane/butane propelled liquid
Color White
Odor Characteristic odor.
Density 0.73 g/cm3 (@ 20°C).
Operating temperature active product 150 to +260 °C
Solubility Insoluble in water



Aerosol 12×400 ML

All statements in this publication are based on service experience and/or laboratory testing. Because of the wide variety of equipment, conditions of use and the unpredictable human factors involved, we recommend that our products are tested on-the-job prior to use. All information is given in good faith but without warranty neither expressed nor implied. This Technical Data Sheet may already have been revised as a result of a change in legislation, availability of components or newly acquired experiences. The latest and only valid version of this Technical Data Sheet will be sent to you upon simple request or can be found on our website: www.crcind.com We recommend that you register on our website for this product, thus enabling you to automatically